China suit wholesale Common pattern adjustments for men's wear: length, shoulders and waist

Lengthening and shortening may be the easiest way to make your finished garment look more fitted. china hemp lining suit factory Clothes that are too short or too long look dated and sloppy... But what is the right length? This is mostly based on individual preferences, but there are some standard rules for most body types.
The shirt should cover the belt or belt and should be finished above the pants zipper. The sleeve should end where the wrist meets the hand, about 1 inch below the carpal bone.
Pants and pants length are the most challenging and are mostly down to personal preference.
1. Lengthening
① Copy the original pattern (paper pattern).china hemp lining suit factory
② Draw an extended/shortened line perpendicular to the texture line and parallel to the hem. The line should be placed relative to where it needs to be extended. For example, if you are short from your chest to your navel, you should place an extension/shortening line between these two points.
③ Cut along lengthening/shortening lines.
④ On another piece of patterned paper, draw two parallel lines that are the number of lines you want to extend. Draws a third row perpendicular to the previous row. This will act as a continuation of your particle line.
⑤ Align your twill pattern block with your extended guide and texture line. Blend serrated edges and trim.
2. Shorten (same method as above)
A well-fitting shoulder is a basic requirement for tailored clothing. The shoulder is where the front piece, the back piece and the sleeve piece all meet, and various fitting problems can affect the shoulder.china hemp lining suit factory
First, it's important to determine what the fitted shoulders look like. Fitted shoulders flat on natural shoulders. The seam at the top of the shoulder should be perfectly positioned at the tip of the shoulder. If this seam is too long or too short, then the poor fit will also affect the underarm and back fit. In these cases, you will see a "ripple effect" that creates bumps or wrinkles in the sleeves and underarms.
1, wide and narrow shoulder adjustment
Patterns are drawn according to uniform codes. It is very common to choose a size based on your chest and waist size that is consistent with your shoulder width.
Rub pattern, remove shoulder and arm seams.
Mark the new end point for shoulder width.
Rotate the full trace until the bottom handrail is in contact with the original side seam.
Repeat on the back of the shirt. Add seams to arm and shoulder seams.
2. Balance shoulder seams
Over the last hundred years, the shoulder seam has moved from the back of the shoulder to a more central point on the shoulder. If you have a rounded back or chest, you may find it necessary to move the shoulder seam slightly forward or backward.
To move the shoulder seam forward, perform the following steps. To move the shoulder seam back, simply move it in the opposite direction.
Print the front and back pieces. Remove seams at shoulder seams.
Draw a new ideal shoulder line on the front piece. Cut along this line.
Place the cut piece on the back of your shoulder.
Add seam allowance.china hemp lining suit factory
3. Print the pattern to remove the side seam allowance and hem allowance.
On the chest, draw a line perpendicular to the texture line that starts at the side seam and ends at the largest part of the chest.
Draw a second line parallel to the grain line, from the entire chest point to the bottom of the garment.
Using paper cutouts, cut along the drawing line, starting at the hem, stopping at the entire chest point, then cutting from the side seam to the entire chest point. Leave a small paper hinge.
The paper hinges rotate outward to pass the middle section more easily and pivot toward the front of the center to eliminate ease.
Lengthen or shorten at the hem of the side seam to compensate for the increase or decrease in length during rotation.